Sample rate problems with multi card setup and SX2

lambchop

Hi Everyone!

I know I haven't posted here in like a dog's age (actually hardly since the forum moved) but I've been lurking and finally have a situation where I need some help from the community.

So I have a problem that I can't figure out. I have a Delta 1010, 1010LT and 66 all synced together running SX2. The cards are synced properly and are recognized by Cubase allowing me to record my band at 16 tracks simultaneously with no problem. However; for some strange reason I can't get a sample rate higher than 48Khz. If I try to set the cards for a higher rate when I open Cubase I get an error message that one of the cards doesn't support the rate (they all go to 96Khz). I've been trying to figure out what I'm doing wrong but don't seem to get anywhere.

Does anyone have any idea what I may be doing wrong? It's starting to drive me nuts!

Thanks in advance for any insight or help that you can give me.

lambchop · Posted: Thu Jul 29, 2010 8:11 pm Post subject:

No takers?

I've tried turning off the Windows sound scheme which I read in another post might have caused a conflict and that didn't work. I'm getting a prompt that one of my cards is not set for external sync, but they all are.

Has anyone else ever experienced this or can think of a possible cause and/or solution?

Any help would really be appreciated. Thanks!

split · Posted: Thu Jul 29, 2010 9:16 pm Post subject:

You could try connecting the word clocks together.

1010 master word-clock to 1010lt to 66 and set the reference clocks to word clock in the lt and 66.
_________________
Split V4.5.2 one day I'll upgrade myself

lambchop · Posted: Fri Jul 30, 2010 5:03 pm Post subject:

Actually, I already have the 1010lt and 66 slaved to the 1010 word clock. That's what bugging me.

Any other suggestions?

split · Posted: Fri Jul 30, 2010 6:45 pm Post subject:

Remove the 66 and see if you can get 96
_________________
Split V4.5.2 one day I'll upgrade myself

lambchop · Posted: Sat Jul 31, 2010 8:31 pm Post subject:

That doesn't help. Plus; the 66 works fine at 44.1khz. What could it be?

split · Posted: Sat Jul 31, 2010 8:40 pm Post subject:

I don't know!

I have an older system in one of my studios that is running a 1010 and a 1010lt locked via word-clock and it can go to 96.
_________________
Split V4.5.2 one day I'll upgrade myself

lambchop · Posted: Thu Aug 05, 2010 8:26 pm Post subject:

Does it recognize all 16 inputs?

split · Posted: Thu Aug 05, 2010 9:13 pm Post subject:

Yes and the two spdif...
_________________
Split V4.5.2 one day I'll upgrade myself